Alinco DX-801 Manual de instrucciones descargar pdf (Pagina 14)

MFJ-925 Super-Compact IntelliTuner Automatic Antenna Tuner Instruction Manual

The MFJ-5114I interface cable provides control signals between an Icom radio and the MFJ

automatic tuner. Supported Icom radios are IC-706, IC-707, IC-718, IC-725, IC-728, IC-736, IC-738,

IC-746, IC-756, IC-7000, and any Icom radio that supports the Icom AH-3 or AH-4 tuner. Push and

hold the radio’s [TUNER] button for two seconds to start the tuning process. Push [TUNER] quickly

to bypass the tuner. Make sure jumper JP4 is removed for IC-7000. Refer to “Icom Radio

Interface” on page 22 for connections and operation.

Pin (Key) connects to pin 6 of Radio Interface Plu

Pin (Start) connects to pin 8 of Radio Interface Plug.

Pin (Ground) connects to pins 4 and of Radio Interface Plug.

Pin 3 (+13.8V) connects to pins 2 and 3 of Radio Interface Plug.

1g.

Figure 7. Icom Interface Cable.

The MFJ-5114K interface provides control signals between a Kenwood radio and the MFJ automatic

tuner. Supported Kenwood radios are TS-50S, TS-450S, TS-480HX, TS-570S, TS-690S, TS-850S,

TS-870S, TS-2000, and any Kenwood radio that supports the Kenwood AT-300 tuner. Push and hold

the radio’s [AT TUNE] button for one second to start the tuning process. Push the [AT TUNE]

quickly to bypass the tuner or to cancel tuning in progress. Make sure jumper JP4 is installed. Refer

to “Kenwood Radio Interface” on page 23 for connections and operation.

Note: The TS-480HX will automatically reduce its TX power to 100 watts maximum (25 watts

AM) when the radio interface is used.

Note: For the TS-2000, use the ANT 1 and AT connectors on the radio to connect an external

antenna tuner. If the external tuner is connected to the ANT 2 connector on the radio, the

external tuner will not function with the radio interface.

Pin 1 (Ground) connects to pin of Radio Interface Plug.

Pin 2 (TT) connects to pin 6 of Radio Interface Plu

Pin (Ground) connects to pin 5 of Radio Interface Plug.

Pin 5 (TS) connects to pin 8 of Radio Interface Plug.

Pin 4 is not connected.

Pin 6 (+13.8V) connects to pins 2 and 3 of Radio Interface Plug.

Kenwood

Rear Panel View

Figure 8. Kenwood Interface Cable.

The MFJ-5114Y interface provides control signals between a Yaesu radio and the MFJ automatic

tuner. Supported Yaesu radios are FT-100, FT-450, FT-857, FT-897, FT-950, and any Yaesu radio

that supports the Yaesu FC-30 tuner. Push and hold the radio’s (TUN) or (TUNE) key to start the

tuning process. Make sure jumper JP4 is installed. Refer to “Yaesu Radio Interface/MFJ-5114Y” on

pages 24 to 27 for connections and operation.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Sin comentarios

Alinco DX-801 Manual de instrucciones Pagina 14