LOCATION Sets the transmission time of GPS data in 10 second increments. 5-6-4
LPATH Sets the outgoing path of GPS data. (Including DIGI-peater(s) used). 5-6-3
LTEXT The GPS data buffer. 5-6-6
LTMON
Displays the LTEXT message as if it were received as a beacon signal
in preset intervals.
5-6-7
MCOM TNC monitors all I frames. 4-7-2
MCON Monitor (or not monitor) other stations while you are connected. 4-7-3
MONITOR Monitor (or not monitor) packet communications. 4-7-1
MRPT Allows monitoring the DIGI-peat route in a packet header (or not). 4-7-5
MYCALL Sets your callsign in the TNC 4-1-2
NTSGRP Adds group-codes into the GPS data. 5-6-10
NTSMRK Adds MARK# in the GPS data. 5-6-11
NTSMSG Add NTS message into the GPS data. 5-6-12
PACLEN Sets the maximum length of the data part of the packet 4-6-3
PACTIME
The interval time until automatic packet transmission after
keyboard input stops, in 100ms units.
4-6-4
PERSIST Sets the CSMA P-persistent probability 4-2-2
PPERSIST Selects P-Persistent CSMA 4-2-1
PORTOUT Sets expanded output port 8-1-1
RESET
Returns TNC to its default parameters. This command also resets
the back-up memories.
9-1-2
RESPTIME Sets the transmission delay time of the confirmed packet. 4-4-7
RESTART Re-starts the TNC. 9-1-1
RETRY Set the number of packet retries before disconnecting. 4-4-9
SENDPAC Sets the characters that command a packet to be sent. 4-6-1
SLOTTIME
Sets the interval of generating random numbers in P-persistent
CSMA.
4-2-3
TRACE Displays the contents of all received frames. 4-7-6
TRIES
Sets the number of attempts to re-send a packet that has not been
acknowledged as received.
4-4-10
TXDELAY
Designates the time delay between PTT and the start of data
transmission.
4-2-6
UNPROTO
Sets the destination of packet and the DIGI-PEAT route while
communicating unconnected.
4-5-2
XFLOW Software flow / Hardware flow controls 3-3-5
3. Connecting to the host PC
3-1 Communication conditions
Set the PC parameters as follows
* Bit rate 9600Bps fixed
* data length 8 bit / 7 bit AWLEN command
* Parity None/Even/Odd Parity command
* Stop bit 1 bit fixed
The following parameters must meet the terminal software’s requirements.
* wireless modem to the host: echo back setting Echo command
* wireless modem to the host: put [LF] after [CR] AUTOLF command
(47 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales